Engineering Design
Our engineer and CAD technicians have helped many architects and engineers during the design phase of a biomass boiler system. Use our expertise to reduce your project design time and ensure your system is operator friendly.
Fabrication
Our uniquely qualified craftsmen will build your system with the trained eye of someone who has also installed many systems.
Installation
The same craftsmen that built your system will also install it. The result is an integrated project where all the parts work together to give the operator a simple, robust, low maintenance system. Low downtime is the mark of a Messersmith system.
Start up/commissioning
A Messersmith field technician will start up your system, test it for proper operation, and tune it to maximize efficiency and minimize emissions. Tuning is done so that the combustion process is matched to your fuel, producing highly efficient, clean combustion. Carbon Monoxide emissions will be less than 100 ppm. Training of local operators will also begin during this week.
Operator Training
During the start up process, Messersmith technicians will begin training the local operators of the system. This training takes place over three or four days during the start-up week, and includes four or five separate sessions. The following topics are covered in our operator training:
- Sensors & Switches
- Motors
- Augers
- Controls and Alarms
- Fire Safety
- Combustor
- Maintenance
- Troubleshooting
- Miscellaneous
A walk through of the system is done starting with the fuel handling and working to the control panel pointing out all the switches and sensors, explaining the operation of its components, and identifying the maintenance points. The complete operation of the control panel is discussed, explaining what each control point is for, and how the control system operates. Next, we go through an ash cleaning and warm start procedure. A cold start procedure is demonstrated. All alarms are described. An explanation of what to look for and how to fix the alarms follows. The operator goes through an ash cleaning and learns all the maintenance points of the system. All alarms are triggered independently. The alarm is cleared and the system restarted by the operator.
Ongoing Parts and Service
Messersmith technicians are available to continue providing parts and service. Since most parts are available from national parts companies, many of our customers choose to acquire their own parts. However, parts are also available from our corporate office for the convenience of our customers. If you are a Messersmith customer, please check the Parts List tab in your Manual to find most part numbers.
Several Service Packages are available:
- Boiler Tuning
- Fireside System Cleaning and Inspection
- Electrostatic Precipitator Cleaning
- General System Inspection
- Other special service needs you may have
For more parts information, or to place an order contact:
purchasing@burnchips.com or call 906-466-9010 ext 1004
For service information contact:
service@burnchips.com or call 802-578-1552